Lezárt

PCB Case Design

A projektre 33 árajánlat érkezett képzett szabadúszóinktól, az átlagos ajánlat a következő volt: $211 CAD.

Kapjon ingyenes árajánlatokat egy hasonló projektre
A munkaadó dolgozik
Projekt költségvetés
$30 - $250 CAD
Összes Árajánlat
33
Projekleírás

I need a PCB case with following characteristic:

- The case should be as small as possible.

- It should be fully water resistant (IP 67).

- It should hold one battery size cr123, (Proffered to access to the battery without any screwdriver)

- Case should have 2 external holes for sockets: 1 micro USB female waterproof connector + female Miniature waterproof micro connector for an external device with minimum 4 pins.

-Case should have a slot for inset & remove a micro SD card. It should be accessed without screwdriver; also it should not defeat the water proof. (One idea for the location of SD card could be behind the battery)

- PCB will be design based on the case shape; however the PCB size could be around (9cm2 or 1.4 inch2)

- PCB has 2 reset switches (miniature push button: [url removed, login to view]). one of them should be accessed easily the other one required inserting a pin into a hole for reset (this is actually a factory reset switch)

- PCB has one small LED, SMD type and to be viewed from outside.

- It is preferred to have minimum number of door on the PCB case.

Szeretne pénzt keresni?

  • Adja meg a költségvetést és a munkaelvégzéséhez szükséges időt
  • Vázolja fel ajánlatát
  • Kapjon fizetést munkájáért

Alkalmazza a szabadúszókat, akik erre a projektre is ajánlatot adtak

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online