Dome Architect

Looking to get architectural drawings I can submit to county in Arizona to build dome structures. Dome already designed and engineered just internal structures need designing. Site Plan Foundation plan Floor framing plan Floor plan Electrical plan Cross Section Elevations o The detail on the Floor Slab. o Show Under-slab duct runs with material type and installation methods. o Electric circuits with conduit and installation methods. •. o Show all braced wall lines and panels. o Door and window locations and sizes. o Emergency exit windows. o Show all exterior decks. o Appliance, water heater, wood stove, fireplaces, and cabinet locations identified. o Show plumbing fixtures. o If a guest house or Accessory Dwelling Unit (ADU), show square footage of primary and ADU. • Electric Plan o Show all Lights locations o Show all Switch locations o Show Grounding electrode type o Show location of main service and sub-panels o Provide Panel Schedule o Provide the Symbol Schedule o Smoke Alarms and Carbon Monoxide Detector location o Show all Receptacle locations • Elevations(front, right and left sides, and rear views) o Four (4) elevations minimum for Single family dwelling and ADU o Type of siding or exterior wall covering. Flashing -- roof to wall. o Show planters and other building projections. o Over-hangs dimensioned. o Provide roof ventilation calculations and area of venting. o Show Chimney Location, Height above the ridge and spark arrestor type. o Show all Decks, Balconies and Porches locations, Guardrails, Stairs, and Landings. o Footings outlined: Show accurate grade line, show stepped foundation locations. o Building height dimensioned: elevations of two or more-story buildings shall show an accurate grade line to determine actual heights of the building. The maximum building height shall be determined by Planning and Zoning, as per the County Zoning Ordinance. • Roof Framing Plan o Load-bearing beams, door and window header, sizes and indicate the length of the span o Garage headers. Size and span. o Post locations and supporting beams o Rafter sizes, direction, and spacing. Ceiling joists. o Truss direction and spacing (engineered). Provide engineered truss specification details o Ridge, valleys, and hips size and labeled o Show blocking and bracing locations on the plans o Show all covered deck roof framing • Cross Section o Make visible all construction elements. o Call out all mechanical connectors and hardware used. ▪ 1. Footing and stem. ▪ 2. Show floor/roof Girders and joists, blocking; or slab with fill. ▪ 3. Studs -- size and spacing. ▪ 4. Floor and roof sheathing, type, and size. ▪ 5. Show Rafters, Engineered trusses, and I-joist. ▪ 6. Identify all Insulation location and type. ▪ 7. Call out all wall elements. ▪ 8. Call out all dimensions. ▪ 9. Show roof over-hang and attic space. ▪ 10. Show stair information with details, show guardrails information with details. • Details – scale ½” = 1’ (half inch equals one foot) or larger o Footing, Stem wall, Piers, and all foundations and material used. o Show all connections and hardware between walls, floors, deck, ceilings, and roofs, etc.