Simple Function Generator

hello i am a computer engineer,i have masters in computer engineering,i have experience for more than 7 years in arduino and electronics i have made a function generator before using arduino so i can help u in ur project

hello, how are you?? are you fine?? i hope so ^_^ My name is Hisham Omar. i am an Embedded System Software Engineer. i worked many times before on Micro-controller(AVR,PIC) programming projects, you can see samples of them in my portfolio, so i see able to perform this task easily. i am looking forward to discuss more details about your project so feel free to contact me any time. Thank you for reading my proposal, i hope you find it fine and start working together. Regards.

hi, what is the shape of the output wave from and what is frequency range? I did it on pic18f series controller in the past.

Greetings, I propose fastest delivery over top solution quality Please message if the proposal makes some interest Thank you, Best Regards,

Hi, I can develop those functions. The only hardware dependent thing that you need is getting the system time in order to calculate the waves values (like microseconds() for Arduino, etc). Everything else is pure C. Please do message me for more details. Best regards, Robert Wallner

I've a very good experience using C with embedded systems specially AVR, try me out, I will do it with best quality and asap.

Hello. I'm qualified engineer. The task is clear to me. Is atmega32 a must or it can be changed to stm32 with DAC onboard?

Very low cost for completing

Hi,I have read your requirements of Simple Function Generator and I’m pretty confident that I will be able to get your work done within the given time your requirements conclude.I am very keen to discuss further. You can reach me at any time on online . I have also a few clarifying questions on the project.I’m an Expert, Honest, Sincere, Quick learner and Responsible worker as I’m taking my work like my Responsibility. kind regards.

experianced in c programming and passionate for it. I know how to deal with dead-lines and i am a professional person.

Hello, I am an electronic engineer, I have knowledge of C programming and AVR I can provide you with the neccessary PCB and gerber files using KiCAD or Eagle PCB software. I can provide with the required software and additional files in the next 48hours after acceptin the project. Thanks for your consideration. Best Regards, Adolfo Sanchez

Hi, I can help you with your project. I have lot of experience with programming microcontrollers and later if you need I can project a PCB board for this project. Best regards.