I need some modification on a C code using Zilog software
- Állapot: Closed
- Díj: $10
- Beérkezett pályamű: 2
A verseny összegzése
Hey there, I have a PCB (controlled by Zilog z8) that is controlling two motors. I have a code that controls both motors at the same time. I need to modify this code so I can control each motor separately. Motor1 has to go forward when (w) is pressed, and go backwards when (s) is pressed. Motor 2 turns left when (A) is pressed, and turn right when (D) is pressed. Motor 1 needs to reach its potential as it will be responsible for moving the car. Motor 2 has to be moved really slow as it will be responsible for steering.
Again, I have the code and it just needs to be modified so it should be an easy job.
Thanks
Ajánlott készségek
A verseny legjobb pályaművei
-
sudhy8 India
-
freelancershajiv Bangladesh
Nyilvános pontosítófelület
Így vágjon bele a versenyekbe
-
Indítson egy versenyt! Gyors és könnyű
-
Kapjon akár több száz pályaművet A világ minden szegletéből
-
Díjazza a legjobb pályázatot Töltse le a fájlokat - csak egy kattintás!