I need source code of embedded software

$30-250 USD

Lezárt

Kiadva ekkor:

körülbelül 5 évvel ezelőtt

$30-250 USD

Teljesítéskor fizetve

I need reverse engineering support. I have an electronic card module and with software. Most of software parts are open source already but small parts are not. Software was designed on IAR 6.7 and module has STM32 and ARM Can you provide to open source part and edit/clean/revise codes and be ready to compiler the software for using?

Embedded Software

Projektazonosító: 18706369

A projektről

5 ajánlat

Távolról teljesíthető projekt

Aktiválva: 5 évvel ezelőtt

Szeretne pénzt keresni?

E-mail cím

A Freelancer oldalán történő árajánlatadás előnyei

Határozzon meg költségvetést és időkeretet

Kapja meg fizetését a munkáért

Vázolja ajánlatát

Ingyen regisztrálhat és adhat árajánlatot munkákra

5 szabadúszó adott átlagosan $173 USD összegű árajánlatot erre a munkára

@fermatliu

Hello I am expert for C/asm programming. I do reverse before. Can you give more information about ur project？ Time & Fee should negotiate later, do U agree

$30 USD 30 napon belül

0,0

(0 értékelés)

0,0

@SimonZhang0212

I have ten years experience in embedded systems, good at using keil or IAR studio,. I think I can help you.

$277 USD 8 napon belül

0,0

(0 értékelés)

0,0

@hayat38402

I'm an electronic engineer with more than 15 years of work experience. I work as HW designer; FW and SW developer. As HW designer, I work in Altium, KiCad and Orcad and I have experience in development single MCU (Microchip PIC and ARM Cortex) boards with several digital I/O (GPIO, UART, SPI, I2C, PWM) and some analog I/O. I design complete board: power section, MCU section, peripheral section, I design also boards with battery power; so I have experience in low power PCB design. I have also experience in commercial boards (Arduino, Raspberry, Beaglebone ) shields design. I have also experience in bluetooth (both 2.0 and 4.0) PCB design.

$250 USD 3 napon belül